Ocean Modeling Discussion

I found the problem, I didn't define AVERAGES in the .h file, after defined it the model run and creates the averages outputs.


Thank you!

Hello
I run 1972080 timesteps, five years, the history files are ok, but any average files were created.

Thank you!

Hello everybody! I'm running a simulation; I need outputs every six hours and daily average, I configured the output options in the ini file as follows: ! Output history, quicksave, average, and diagnostic files parameters. LDEFOUT == T NHIS == 270 ! Cada 6 horas con DT 80 seg NDEFHIS ==270 NQCK ...

Thank you, Arango and Kate; I had a problem restarting my model in the past, so I tried running the model once time.
In this time, I was able to restart without a problem, and the two solutions helped me.



Thank you.
Gabriela

Thank you for your help, Kate! I made the changes and will run the model.

Hello everybody! I have a problem to restart a simulation and I hope someone could help me. I have the roms_rst.nc file and I used as initial file and changed the NRREC, but when I try to run the model has a problem, the data that the model read from the boundary file is the initial, not the data at ...

Hello! I hope I can help you a little. Did you check that the oxygen was activated in the .h file? And, are you sure that the boundary configuration in the fennel.in file is correct? I think, maybe something is wrong in one of this files. A doubt, how do you kmow that the results of the boundary isn ...

Hello everybody! I have a doubt, I have a NPZD_Powell version of the model and I'm trying run a Fennel version, so I change the boundary data, the forcing and grid are the same. I ran the first model in a past version of ROMS, now I'm working with the 3.9 version and I have a problem with the ...

Hello! If the area is very shallow the problem can be the heat flux, you can try use the forcing and Qcorrection instead of Bulk Fluxes. I had a very similar problem in a shallow domain, the temperature was very high or very low.

Hi everybody! I'm running the NPZD_Powell model but the output of biological variables have negatives values. I see in the forum that the TS_MPDATA advection scheme is a solution for the problem but I can't use because I'm working in a workstation with OpenMP. Do you have any other idea about how ...

Hello! I'm working in a coastal lagoon model with a river, but I have a problem. In the surface the salinity is normal but in the three last levels in the point of origin of the river the salinity is too high. I tried with diferents salinitys and transports (negative and positive) and the problem is ...